Connecting the VP-81KSi 8x1 UXGA/Audio STEP-IN Switcher
11
6.2 Connecting Remote Contact Closure Input Selection Switches
You can connect remote input selection switches to the Remote terminal block on
the rear panel of the
VP-81KSi
which enables you to remotely activate the relevant
input.
The following example (see
Figure 6
) illustrates three switches (A, B and C)
connected to remotely controlled inputs 1, 2 and 3 respectively (up to eight
switches can be connected). Pressing switch A causes input 1 on the
VP-81KSi
to
be the active input, pressing switch B causes input 2 to be the active input, and
pressing switch C causes input 3 to be the active input.
Figure 6: Remote Input Selection Switch Wiring
To connect remote input selection switches as illustrated in the example in
Figure 6
:
1. Connect Switch A to pins 1 and G
1
2. Connect Switch B to pins 2 and G
on the terminal block.
1
on the terminal block.
3. Connect Switch C to pins 3 and G
1
on the terminal block.
4. If required, repeat for a total of up to eight switches.
6.3 Connecting the SI-1VGA Remote Step-in Module
For detailed instructions refer to the
SI-1VGA
Step-in Module Installation
Instructions
2
To connect an SI-1VGA remote step-in module to the VP-81KSi as illustrated
in the example in
.
Figure 7
:
1. Mount the
SI-1VGA
in either the
TBUS-10
or the
K-POD301
.
1 You can connect any of the switches to either of the two Gnd connections
2 Available for download from
http://www.kramerelectronics.com
gpd.sunwayinfo.com.cn