Kramer VP-774, Руководство пользователя

Страница: 33 / 85

28 VP-774 - The OSD Menu
Setting Function
Mic Effects
(continued) For Mic 2, set the:
Mic2 Mix [dB]
– set to 1 to enable the Talkover mode or set to any other value
to decrease the Mic2 volume without changing the Line out and Mic1 volume
levels.
Mic2 Talkover Depth [ % ]
– to determine the decrease of the audio level during
microphone 2 takeover (press + to further decrease the talkover audio output
level; press
– to lessen the talkover output audio decrease level)
E
Mic2 Talkover Trigger [dB]
– to determine the microphone 1 threshold level
that triggers the audio output-level decrease E
Both microphone inputs can be output along with the audio output
in the
Talkover (default) mode or the Mix mode, separately or together.
In the Talkover mode (Mic Mix is set to 1), the audio output volume level
decreases when the microphone is used and it returns back to its original set
level when the microphone input is inactive.
In the Mix mode, the microphone input is mixed with the audio output at a set
level.
For each microphone input you can set the Mic Talkover Depth, Mic Talkover
Trigger and Mic Mix independently. You can also set the Line Mix separately.
Embedded Set:
Pass-through
– to On to pass the digital audio input directly to the output
without any processing or set to Off to process the digital audio input E
Note that this feature is disabled for the non-embedded audio
inputs (PC and CV)
In case the audio signal is encrypted or compressed set the
Pass-through to On, although in some cases there may not be
sufficient capacity to accurately transmit the audio.
Analog Takeover
– to On for the analog inputs of the HDMI and DP inputs to
take over the embedded inputs; select Off to use the embedded inputs E
Analog takeover is available only if an unbalanced audio signal is connected
(via 3.5mm connecter). When set to On, the embedded audio is disabled as
long as the 3.5mm cable is connected to the 3.5mm mini jack
Delay Set:
Lip Sync delay value [msec] E
Mic1 Delay value [msec] E
Mic2 Delay value [msec] E
SDI
Channeling Set the SDI channeling for groups A, B, C and D and connect the active and the
bypassed channels (see
Section
6.3.1
)
By default, groups A and B are connected and groups C and D are disconnected
Set the SDI channeling for groups A, B, C and D to Activate CH1, Activate CH2
or Bypass. If other groups are set to Activate or Bypass, the remaining groups
are read as None
Set Bypassed channels to
Unmute or Mute (see Section
6.3.1.1
)
i