Connecting a VP-214DS 4 Channel Automatic XGA Switcher
7
6 Connecting a VP-214DS 4 Channel Automatic XGA Switcher
This section describes how to:
Connect the
VP-214DS
unit (see section 6.1)
Connect the
VP-214DS
for control via RS-232 (see section 6.2), RS-485 (see
section 6.3) and/or the Ethernet (see sections 6.4 and 6.7)
Connect several
VP-214DS
machines (see section 6.6)
Set the dipswitches (see section 6.5)
Reset the unit (see section 6.8)
6.1 Connecting a Single Unit or Several VP-214DS Machines
To connect the
VP-214DS
4 Channel Automatic XGA Switcher
, connect the
following to the rear panel (see Figure 3):
1. For each channel
1
(A, B, C and D):
Connect XGA sources to the IN 1 and IN 2 connectors (for example
a computer or a laptop)
Connect the OUT connector to a computer graphics acceptor (for
example, a monitor or a projector)
Connect an additional monitor to the LOOP connector if required
2
2. Connect the power cord
3
(not shown in Figure 3)
3. Connect to a controlling device (optional – see sections 6.2, 6.3 and 6.4).
4. Connect the RS-485 port to additional units (optional – section 6.6).
5. Set the dipswitches (see section 6.5).
1 You do not have to connect the inputs on all channels
2 When connecting an additional monitor, press the channel’s TERM button
3 We recommend that you use only the power cord that is supplied with this machine
im Vertrieb von CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
