Using Your VP-12N 1:12 + 3 UXGA / CAT5 Distributor
5
4. On the
VP-12N
, connect
1
the CAT5
RJ-45
2
:
OUT 1 connector to the
LINE IN RJ-45 connector on a
TP-120
unit, and
connect the XGA OUT connector on that
TP-120
unit to Display 1
OUT 2 connector to the
LINE IN RJ-45 connector on a second
TP-120
unit,
and connect the XGA OUT connector on that second
TP-120
unit to Display 2
OUT 3 connector to the
LINE IN RJ-45 connector on a third
TP-120
unit,
and connect the XGA OUT connector on that third
TP-120
unit to Display 3
5. Connect the power cord
3
(not illustrated in Figure 3).
6. Adjust
4
the blue, green and red signal levels, if required.
Figure 3: Connecting the VP-12N 1:12 + 3 UXGA / CAT5 Distributor
1 Via UTP cabling, with a range of more than 300ft (>100m): see section 5.1
2 The TP-120 units may be powered via this connector (instead of via the 12VDC external supply)
3 We recommend that you use only the power cord that is supplied with this machine
4 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level