Kramer Electronics Ltd.
Galil 6-AW - Installing the Galil 6-AW
6
3. Adjust each speaker to the appropriate tap setting:
Set the tap
according to the power requirements of the speaker based on its
location in the room (for example, a speaker located in a remote corner may require
additional power).
Figure 2: Adjust Tap Selector
4. Connect the wires to the appropriate terminal block connectors
on the speaker (see
Figure 3
).
5. Mount the grommet/cable gland on the protective cover
and pass the cables through
the
grommet/cable gland and the protective cover
.
6. Close the tap selector and connector opening with the protective cover
.
7. Mount the U-brackets
, see
Installing the Mounting U-Brackets
, on page
7
.
8. Pass the speaker wires through the round hole in the mounting U-bracket.
9. Connect one of the + and
–
terminal block pairs on the rear
panel by connecting the wire from
the:
Left speaker wires to amplifier
“L” terminal blocks.
Right speaker wires to amplifier
“R” terminal blocks.
Figure 3: Adjust Tap Selector
10. If required, connect the + and - terminal blocks to the + and - terminal blocks of an
adjacent speaker (as illustrated in the example in
Figure 5
).
