Kramer Electronics Ltd.
DSP
‑
1
– Connecting DSP
‑
1
6
Connecting to DSP
‑
1 via RS-232
You can connect to the
DSP
‑
1
via an RS-232 connection to the RS-232 port
using, for
example, a PC.
Connect the RS-232 terminal block on the rear panel of the
DSP
‑
1
to
a PC/controller, as
•
TX pin to Pin 2.
•
RX pin to Pin 3.
•
GND pin to Pin 5.
Figure 3: RS-232 Connection
Connecting DSP
‑
1 via the Ethernet Port
You can connect to the
DSP
‑
1
via Ethernet using either of the following methods:
•
Connecting the Ethernet Port Directly to a PC
•
Connecting the Ethernet Port via a Network Hub or Switch
If you want to connect via a router and your IT system is based on IPv6, speak to your IT
department for specific installation instructions.
Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the
DSP
‑
1
directly to the Ethernet port on your PC using
a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the
DSP
‑
1
with the factory
configured default IP address.
After connecting the
DSP
‑
1
to the Ethernet port, configure your PC as follows:
1. Click
Start
>
Control Panel
>
Network and Sharing Center
.
2. Click
Change Adapter Settings
.
3. Highlight the network adapter you want to use to connect to the device and click
Change
settings of this connection
.