6 Installation, removal and connection
6.3 Installing the EET in OMG
6.3 Installing the EET in OMG
Personnel qualification:
o
Electrician
Personal protective equipment:
o
Work clothing
Aids:
o
Torque wrench
WARNING
Risk of injury through escaping medium.
Media can be hot, poisonous, combustible and caustic.
► Before installing the sensor, switch off the system and depressurise it.
► Wear personal protective equipment at all times during operation. Pay attention to face protection.
► Collect any escaping medium safely and dispose of it in an environmentally compatible manner in
accordance with the applicable local regulations.
ATTENTION
Incorrect installation destroys the sensor
► Select the correct installation location.
X
X
1
1
2
2
OMG 32
OMG 52
1.
Select the correct bore and remove the screw plug from the sensor bore.
2.
Clean the sensor bore. No foreign bodies should penetrate the flowmeter
2
or piping system.
3.
Select suitable sensor
1
,
Ä
4.
Screw the sensor into the sensor bore as far as it will go, maximum tightening torque 30 Nm.
5.
Connect the sensor cable, observing the connection diagram.
Ä
6.4 Installing the EET in OMP
Personnel qualification:
o
Electrician
Personal protective equipment:
o
Work clothing
Aids:
o
Torque wrench
WARNING
Risk of injury through escaping medium.
Media can be hot, poisonous, combustible and caustic.
► Before installing the sensor, switch off the system and depressurise it.
► Wear personal protective equipment at all times during operation. Pay attention to face protection.
► Collect any escaping medium safely and dispose of it in an environmentally compatible manner in
accordance with the applicable local regulations.
10
OII 08en-GB Edition 2021-07
Operating instructions
