
43
SPLIT-TYPE ROOM AIR CONDITIONER
USER GUIDE
Indoor unit installation
Installing the Mounting Plate
• Decide an installing location for the mounting plate
according to the indoor unit location and piping direction.
• Keep the mounting. plate horizontally with a horizontal
ruler or dropping line.
• Drill holes of 32mm in depth on the wall for fixing the
plate.
• Insert the plastic plugs to the hole, fix the mounting plate
with tapping screws.
• Inspect if the mounting plate is well fixed. Then drill a hole for piping.
Attention: The shape of your mounting plate may be different from the one above, but
the installation method is similar.
Attention: As the above figure shown, the six holes matched with tapping screw on the
mounting plate must be used to fix the mounting plate, the others are prepared.
Drill a Hole for Piping
• Decide the position of hole for piping according to the
location of mounting plate.
• Drill a hole on the wall. The hole should tilt a little downward
toward outside.
• Install a sleeve through the wall hole to keep the wall tidy
and clean.
Indoor Unit Piping Installation
• Put the piping (liquid and gas pipe) and cables through the wall hole from outside or put them
through from inside after indoor piping and cables connection complete so as to connect to
outdoor unit.
• Decide whether saw the unloading piece off in accordance with the piping direction.(as shown
below)
Attention:
When installing the pipe at the
directions 1,2 or 4, saw the corresponding
unloading piece off the indoor unit base.
• After connecting piping as required, install the drain hose. Then connect the power cords. After
connecting, wrap the piping, cords and drain hose together with thermal insulation materials.
Outdoor unit installation
1. Install Drain Port and Drain Hose
(for heat-pump model only) The condensate drains from the
outdoor unit when the unit operates in heating mode. In order not to disturb your neighbor and
protect the environment, install a drain port and a drain hose to direct the condensate water. Just
install the drain port and rubber washer t the chassis of the outdoor unit, then connect a drain
Содержание KF-CE07
