Kozy-World FBD3211R, Руководство пользователя, Страница: 23 / 31

23
OFF OPERATION
Press the OFF key and the appliance flame will shut off.
During this time the LCD screen will show OF (figure 30).
After 3 seconds the LCD screen will default to display room
temperature and the wood TEMP will show (figure 31).
THERMOSTAT FUNCTION
SETTING DESIRED ROOM TEMPERATURE
This remote control system can control the thermostat
when the transmitter is in the THERMO mode (The word
ROOM must be displayed on the screen ). To set the
THERMO MODE and desired room temperature, Press
the MODE key until the LCD screen shows the word
ROOM. Then the remote is in the thermostatic mode.
Press and hold the SET key until the desired set temperature
is reached. (By pressing and holding the set key the LCD screen
set numbers will increase from 45
° to 99 ° and then restart over at 45 ° )
Next release the SET key. The LCD screen will display the set temperature for 3 seconds and the LCD screen will
flash the set temperature for 3 seconds. Then the LCD screen will default to display the room temperature.
TO CHANGE THE SET TEMPERATURE
Press and hold the SET key until the desired set temperature is reached. (By
pressing and holding the set key the LCD screen set numbers will increase
from 45
° to 99 ° then restart over at 45 ° ). Next release the SET key. The LCD
screen will display the set temperature for 3 seconds. Then will flash the set
temperature for 3 seconds. Then the LCD screen will default to display the room
temperature. Press the MODE key to disengage the thermo mode.
The word ROOM on the LCD screen will not show when the thermo is not in
operation.
NOTE: The highest SET temperature is 99 ° F (32 ° C) and the lowest temperature
is 45 ° F (6 ° C).
REMOTE CONTROL OPERATION NOTES:
The Thermo Feature on the transmitter operates the appliance whenever the ROOM TEMPERATURE varies a certain
number of degrees from the SET TEMPERATURE.
This variation is called the
“ SWING ” or TEMPERATURE DIFFERENTIAL. The normal operating cycle of an appliance
may be -4 times per hour depending on how well the room or home is insulated from the cold or drafts. The factory
setting for the
“ swing number ” is 2. This represents a temperature variation of +/-2 ° F (1 ° C) between SET temperature
and ROOM temperature, which determines when the fireplace will be activated. The transmitter has ON and OFF manual
functions that are activated by pressing either button on the face of the transmitter. When a button on the transmitter is
pressed the word ON or OF will appear on the LCD screen to show while the signal is being sent. Upon initial use, there
may be a delay of three seconds
before the remote receiver will respond to the transmitter. This is part of the system ’ s
design.
Figure 30 Figure 31
Figure 32
Figure 33