22
GAS FIREPLACE INSERT SETUP
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
#RVT-29-BW R.2 July 2018
9.3 Panel Installation
WARNING: RISK OF FIRE! Do not operate this fireplace insert without
a refractory or black enamel panel kit installed.
•
Refractory or black enamel panels will provide insulation and
are required to operate this fireplace.
•
If converting to propane, complete the conversion before
installing any refractory or black enamel panels. Follow
instructions included with the kit.
BEFORE INSTALLATION:
1. Remove the safety screen barrier, glass assembly, media, and
ash panels (if installed).
2. Locate the (2) screws in the front of the firebox and locate the
(2) refractory clips shipped with the panels. These clips are
shipped flat. Bend the metal finger at a 90° angle.
9.3.1 RT29-CB900, RT29-L900, RT29-RB900
1. Install the back panel. Position the larger rectangle cut out to
the bottom of the firebox.
2. Install ash panel.
3. Install side refractory by sliding into position. Secure side
refractory with the panel clips previously bent.
4. Reinstall all components previously removed.
9.3.2 RT29-B900
1. Install the side 16-gauge backer plates. The flat edge along the
front of the plate positions at the bottom of the firebox. Tilt
the bottom of the plate in first. The plates will install along the
side of the burner and sit on the firebox floor.
2. Install the rear porcelain panel, positioning the rectangle cut
out to the bottom.
3. Install the side porcelain panels. These are specific to each side
and are distinguishable by the flange on the bottom that faces
inward.
4. Secure side panels with the panel clips previously bent.
5. Install ash panel.
6. Reinstall all components previously removed.
9.3.3 RT29-BG900
1. Install the 16-gauge back plates to each side of the firebox.
Position the flat edge along the front to the bottom of the
firebox. Tilt the bottom of the plate in first. The backer plates will
install along the side of the burner and sit on the firebox floor.
2. Install the rear glass panel, positioning the rectangle cut out to
the bottom. The textured side of the glass is the backside of the
panel.
3. Install the side glass panels. The textured side of the glass is
the back of the panel, and the top edge will tuck behind the
extended lip at the top of the firebox.
4. Install ash panel.
5. Secure side panels with the panel clips previously bent.
6. Reinstall all components previously removed.
Figure 9.3, Refractory Panel Installation
Figure 9.4, Side Backer Plate and Glass Panel Installation
