#NDK-34-i R.1 July 2022
Hussong Mfg. Co., Inc. Kozy Heat Fireplaces
30
GAS FIREPLACE INSERT SETUP
9.5
Control Board Removal and Installation
WARNING: If burner and/or pilot have been burning, use appropriate
protection to avoid burns or damage to personal property before
removing any components. DO NOT OPERATE THIS APPLIANCE
WITHOUT THE SEALING GASKET (LOCATED UNDER THE CONTROL
BOARD) IN PLACE. IF GASKETING IS DAMAGED, IT MUST BE REPLACED.
CAUTION: Check all connections for leaks with soapy water, whether
field or factory made.
9.5.1
Control Board Removal
1.
Disconnect electrical power. Locate the main shut-off valve
upstream of the appliance connector and close valve.
2.
Remove the log rack/media tray.
3.
Remove front light kit (2) screws.
Loosen (2) 7/16” nuts to remove
left and right burner assemblies.
4.
Remove rear burner assembly (1) screw.
5.
Remove rear burner assembly.
6.
Remove (10) screws securing the control board on the left side of
the firebox. Loosen 7/16” nut securing control board arm.
7.
Pull out control board out to reveal gas line to disconnect the
gas line flex tube from fireplace valve.
9.5.2
Control Board Installation
1.
Place control board on the left side of the firebox and reconnect
gas line to fireplace valve.
2.
Verify sealing gasket is in place. Secure board with (10) screws
previously removed. Tighten 7/16” nut securing control
board arm.
3.
Reinstall rear burner assembly.
4.
Reinstall left burner assembly pushing it towards center until it
stops against the rear burner, then secure. Repeat this process
with the right burner assembly. Tighten previously loosened
screws. Reinstall front light kit with (2) screws previously
removed.
5.
Reinstall log rack/media tray.
6.
Reconnect electrical power.
7.
Verify proper log placement, operation of fireplace, and any
electrical components.
