22
GAS FIREPLACE INSERT SETUP
9.3 #J34-500 Log Set Installation
CAUTION: Do not place logs directly over burner port holes.
Improper log placement may affect flame appearance and
cause excessive soot to build upon the logs and glass.
• If converting to LP (propane) gas, complete the conversion
before installing the log set. Follow the conversion
instructions included with the kit.
• Log numbers are located on the bottom of each log. Refer
to the following instructions and illustrations for proper log
placement.
1. Place the ember panels behind the front burner ports as
shown below.
2. Align the holes in the bottom of logs J34-1, J34-2, and J34-3
with the mounting pins on the back burner. Push to seat.
3. Position log J34-4 as shown below.
4. Position log J34-5 over the two ember panels as shown
below.
5. Align the pins in logs J34-6 and J34-8 with the holes in base
log J34-1. Push to seat.
6. Align log J34-7 with the notches in log J34-1 and J34-5 as
shown below.
7. Use a stiff or steel bristle brush to distribute rockwoll embers
onto the burner and logs.
Figure 9.3, Base Logs
Figure 9.4, Completed Installation
