22
GAS FIREPLACE INSERT SETUP
9.3 #J30-500 Log Set Installation
CAUTION: Do not place logs directly over burner port holes.
Improper log placement may affect flame appearance and
cause excessive soot to build upon the logs and glass.
• If converting to LP (propane) gas, complete the conversion
before installing the log set. Follow the conversion
instructions included with the kit.
• Log numbers are located on the bottom of each log. Refer
to the following instructions and illustrations for proper log
placement.
1. Place the ember panels behind the front burner ports as
shown below.
2. Align the holes in the bottom of logs J30-1 and J30-2 with the
mounting pins on the back burner. Push to seat.
3. Align the holes in logs J30-3 and J30-4 with the pins on the
bottom refractory clips, as shown below.
4. Position log J30-5 over the two ember panels as shown
below.
5. Align logs J30-6 and J30-8 with the notches on the base
logs, as shown below.
6. Align log J30-7 with the notch in log J30-5 as shown below.
7. Use a stiff or steel bristle brush to distribute rockwoll embers
onto the burner and logs.
Figure 9.3, Base Logs
Figure 9.4, Completed Installation
