ADJUSTMENT
31
RESTRICTOR PLATE
BEND TABS TO APPROX. 80° ANGLES TO CREATE
TENSION TO HOLD ITSELF IN PLACE WHEN INSTALLED
REMOVE CIRCLE TO
CREATE LESS RESTRICTON
Figure 10.5, Vent Access and Restrictor Plate
10.2.2.2 Restrictor Plate Installation
1. Remove the safety barrier and the glass frame assembly.
2. Remove (4) screws at the firebox back wall securing the
baffle. Remove baffle to access venting.
3. Bend the tabs on the restrictor plate (included in components
packet) to approximately 80° angles. This will create tension
when the restrictor is inserted into the exhaust pipe.
4. Insert restrictor into the 4 in (102 mm) exhaust pipe with the
tabs pointing towards you.
5. Reinstall baffle by resting the front of the baffle above flange
along the inside top of firebox opening. Tip the baffle against
the firebox back wall, and secure with (4) screws previously
removed.
6. Reinstall all components previously removed.
10.2.2.3 Restrictor Plate Modification
1. Remove the safety barrier and the glass frame assembly.
2. Remove (4) screws at the firebox back wall securing the
baffle. Remove baffle to access venting.
3. Remove the restrictor by pulling it down and out of the 4 in
(102 mm) exhaust pipe. Make necessary modifications to
achieve desired flame appearance.
4. Insert restrictor into the 4 in (102 mm) exhaust pipe with the
tabs pointing towards you.
5. Reinstall baffle by resting the front of the baffle above flange
along the inside top of firebox opening. Tip the baffle against
the firebox back wall, and secure with (4) screws previously
removed.
6. Reinstall all components previously removed.
(4) SCREWS SECURING BAFFLE
