33
SYSTEM OPERATION
INITIALIZING THE SYSTEM FOR THE FIRST TIME
NOTE
This procedure must be performed every time batteries are replaced in Receiver or Transmitter.
1. Move slider switch on receiver to
OFF
position.
2. Install 4 AA batteries (included in components packet) into receiver battery
bay.
3. Using the end of a paper clip, or other similar object, press button through
hole marked
PRG
on receiver front cover. Receiver will ‘beep’ three (3)
times to indicate it is ready to synchronize with a transmitter.
4. Install 3 AAA batteries (included in components packet) into transmitter
battery bay (located on base of transmitter). Push the
ON
button. The
receiver will beep four (4) times to indicate the transmitter’s command is
accepted and set to the particular code of that transmitter.
5. Push
OFF
button on transmitter. The receiver will ‘beep’ two (2) times to
indicate the transmitter’s command is again accepted.
6. Move slider switch to
REMOTE
position.
7. Turn On fan control module, switching to ON (
|
) position.
8. The system is now initialized.
TURN ON THE APPLIANCE
Press
ON/OFF
key on transmitter. The display will show all active icons on the screen. A single ‘beep’ from receiver will confirm
reception of the command.
TEMPERATURE DISPLAY
With the system in
OFF
position, press Thermostat Key and Mode Key at the
same time to change from degrees F to C. Look at transmitter LCD screen to
verify that C or F is visible on right side of Room Temperature display.
TURN OFF THE APPLIANCE
Press
ON/OFF
key on transmitter. The display will show only room temperature and icon on the screen. A single ‘beep’ from receiver will
confirm reception of the command.
Figure 33b
Figure 33a
