User’s Manual
NETIO-230A
www.koukaam.se
22
5.4
Manual control
Outputs could be also controlled manually using two buttons on the front panel. Keep the
Select
button pressed for three seconds. LED indicator in the right button will become lit – you have
switched the device to manual control mode. Immediately after the device enters this mode you will
hear a beep sound, which signalizes that the first output is now active. Press the
ON/OFF
button to
switch its status. If you press the
Select
button again the second output will become active. Outputs are
cycling from the first to the fourth. After each press of the button you will hear a beep sounds. By
counting the beeps you can find out which output is currently selected. After ten seconds of inactivity
the LED indicator will switch off and the manual control mode will be turned off.
5.5
Troubleshooting
5.5.1
Reset to factory defaults
If you forget administrator’s password you must reset the device to factory default values in order to
regain the access to it. You can perform factory defaults reset by pressing both front panel buttons
(
Select
and
ON/OFF)
at the same time
for four seconds. After four seconds there will be two short
beeps, signalizing that the device has reverted to its factory defaults.
5.5.2
Fuse replacement
If your NETIO-230A won’t work and the main switch is not lit it is possible that the fuse has burned.
Before you proceed to the fuse replacement make sure that the device is
TURNED OFF
and
DISCONNECTED FROM THE NETWORK
. Also disconnect all devices connected to NETIO
outputs.
To replace the fuse pull out the plastic fuse holder in the back of the device. Always make sure
you are replacing the fuse by the fuse of the same type! After replacing the fuse, push the fuse holder
back in. Connect the power cable and try to turn the device on. If the problem was eliminated by the
fuse change the switch button will lit. Before you connect all devices back to the NETIO outputs make
sure that the fuse was not destroyed by connected device that is defective.