User’s Manual
NETIO-230A
www.koukaam.se
20
system eth <dhcp | manual> [<ip_address> <mask> <gateway>]
Setup of the network interface parameters – IP address, subnet mask and gate way parameters
are needed to pass only if
manual
mode is entered. To allow changed values to take effect you must
restart the device by typing the
reboot
command or turning it off and on again.
Example:
Command
system eth manual 192.168.10.150 255.255.255.0 192.168.10.1
will set IP
address 192.168.10.150, subnet mask 255.255.255.0 and default gateway 192.168.10.1.
email server < ip | domain_server_address>
Sets IP address or domain name of the SMTP server.
system discover <enable|disable>
Enables / Disable visibility of the device for the network Discover utility.
system discover
Shows if the system discover is enabled or disabled.
system swdelay <delay in 0.1s>
Sets delay between triggering two outputs.
system swdelay
Shows current delay between triggering two outputs setting.
system dns <ip>
Sets IP address of the DNS server.
To allow changed values to take effect you must restart the device by typing the
reboot
command or turning it off and on again.
system dns
Shows current IP address of the DNS server.
system sntp
Shows current SNTP client settings.
system sntp <enable|disable> <sntp ip|domain>
SNTP client settings, enables or disables time synchronization with SNTP server. Server
address can be entered both as IP address or domain name.
system time <YYYY/MM/DD,HH:MM:SS>
Sets local system time.
system time
Shows current local system time.
system timezone <+|-offset>
Sets local time zone.
system timezone
Shows current local time zone offset. Presented value is in seconds.