7
The
Reset
Button (
) on the back of IPCorder:
• Pressed for less than 3 seconds it will restart the device from the Normal to the Service mode, if in Service mode
it will return to the Normal mode if the Reset Button is pressed again.
• If pressed for more than 5 seconds and the power cable is connected simultaneously the factory settings will restore.
We draw attention that in this case all the settings will be irretrievably lost including the saved recordings.
• If pressed for more than 15 seconds the device will be immediately switched off. We wish to point out that in such
a case the saved recordings may be damaged.
The acoustic signals are activated in the following situations:
• By a brief sound when the device is switched on or off by pressing the ON/OFF button.
• By a continuous sound if there is a problem with the RAID disk array (can be switched off by briefly pressing
the front ON/OFF button).
• By a continuous sound of the temperature of the device exceeds 42 °C and if the back panel of the device is removed
or incorrectly attached (the signal cannot be switched off, it ends on its own once the temperature falls below 38 °C
or the back panel is attached).
• By a continuous sound if the temperature of the device exceeds 60 °C (it can be switched off by briefly pressing
the front ON/OFF button). IPCorder will also e-mail information (if the SMTP is setup) and will make an entry
in the log.
• By a continuous sound if the temperature of the device exceeds 70 °C. The device in this case will make an entry
in the log, send an information e-mail (if the SMTP is set up) and will be automatically switched off.
• If the temperature limits are exceeded the acoustic signal is accompanied by the blinking of a red light on the lightstrip.
4. System Requirements
The system requirements are partly dependent on the version of the installed firmware. The client computer should meet
the following minimum requirements for the installed firmware:
•
Operating system:
Microsoft Windows 2003, 2008, XP, Vista, 7 (32 and 64 bit version); Mac OS X 10.5
(only Intel x86), 10.6 and 10.7; Linux 2.6 or newer (recommended JAVA ORACLE co.)
•
Internet browser:
Mozilla Firefox 10 ESR, 14 and newer (recommended); Internet Explorer 8 and 9 (only 32-bit
version); Chrome 21 and newer; Safari 5 (only on Mac OS X).
• Enabled JavaScript and Cookies (check the settings of your internet browser).
• Version Java Oracle 6 or newer (always only 32bit version), we recommend Oracle JAVA 7 – freely available
for downloading on the website
•
Hardware configuration:
depends on the type and number of monitored cameras, the minimum recommended
is a 2 GHz processor and 1 GB RAM.
IPCorder allows the user to download entire videos and pictures from videos saved on a hard disk. The pictures are in
standard JPEG format and can be displayed in every standard picture browser. You need an installed FFDShow codec
or other similar filter to play a video. The simplest way is to play videos in a VLC player which already contains all the
