Kostrzewa Platinum Bio ecoMAX860P3-O TOUCH (VG), Руководство пользователя

Страница: 62 / 94

62
Platinum Bio ecoMAX 860P
User Manual – EN 03.17
Leader in pellet boilers
8. Operation
Use Decrease value to set decrease in temperature for all time intervals. The
nighttime setback can be defined individually for every day of the week in
Schedule. Press a button to set the temperature setpoint reduction for a specific
time interval. Time intervals for 24 hours are set every 30 minutes.
TIME INTERVAL IS OMITTED WHEN DECREASE VALUE IS SET TO 0,
EVEN IF THE TIME RANGE IS SET.
8.22 Fuel level configuration
The controller uses fuel level sensor to monitor fuel level.
Set
Fuel level sensor
to
Enabled
in:
Service settings > Burner settings > Storage bin settings
When the fuel level is below the fuel level sensor, the controller will display the
following message:
„Low fuel level” and will continue feeding the fuel until the minimum fuel level
is reached. In fuel reserve mode, the remaining fuel (in kilograms) is displayed
in the main screen. If no fuel is added by the user, and the reserve is used, the
controller with shutdown the burner before the feeder is completely emptied.
Set
Fuel level sensor
to
Disabled
to disable the fuel level sensor. Fuel level
will be monitored as described below. The controller features a second fuel
level control system, which indicates current fuel level at all times. The level is
determined based on the feeder output, storage bin capacity or based on the
storage bin calibration. The control system can be disabled by setting the alarm
level to OFF.
Boiler settings > Fuel level > Alarm level
Tip: fuel level can also be checked on the ecoSTER TOUCH room temperature
controller.
•
Fuel level indicator: Every time the fuel is added to the storage tank, press
and hold current fuel level value, the following message is displayed:
’’”Set fuel level to 100%”. Press YES to set fuel level to 100%.
Note: The fuel can be added anytime, i.e. there is no need to wait for
the fuel storage tank to be completely emptied. The fuel must be added to
100% level and the level set to 100% as described.
• Operation: The controller determines fuel level based on its consumption.
The factory settings will not always reflect the actual fuel consumption,
and thus fuel level calibration may be required. No additional fuel level
sensors are required.
• Calibration: Add the fuel to the storage tank to the level corresponding to
its 100% capacity and set the following parameter:
Boiler settings > Fuel level > Fuel level calibration >
Fuel level 100%
The fuel level indicator in the main window is set to 100%.
The calibration process is indicated by a blinking fuel level indicator. The
indicator blinks until the point corresponding to the minimum fuel level is
set. Check fuel level in the storage bin regularly. When minimum level is
reached, set the following parameter:
Boiler settings > Fuel level > Fuel level calibration >
Fuel level 0%
Calibration is not required, if Feeder output and Storage bin volume are
set in:
Service settings > Burner settings > Operation
8.23 Info
Info menu allows to view measured temperature and all installed devices.
IF THE MIXING VALVE EXTENSION MODULE IS INSTALLED,
ADDITIONAL INFO SCREENS ARE AVAILABLE. „CAL” MESSAGE IN THE
INFO SCREEN BY THE VALVE POSITION INDICATES CALIBRATION.
IN PROGRESS. WAIT UNTIL THE MIXING VALVE ACTUATOR
CALIBRATION IS FINISHED (CURRENT STATUS IS DISPLAYED).
8.24 Manual control
The controller allows to disable the devices, i.e. pump, feeder motor or fan
manually to check device functions and wiring.
MANUAL CONTROL MENU CAN BE ACCESSED IN STAND-BY MODE
ONLY, I.E. WITH BOILER SHUTDOWN.
PROLONGED OPERATION OF THE FAN, FEEDER OR OTHER DEVICE
MAY RESULT IN A HAZARD.