Kospel EKCO.A1, Руководство пользователя

Страница: 4 / 12

4
Installation
1. In order to take off the front cover,
undo the fixing screws and discon-
nect the protective wire. For fixing the
unit permanently leave free space at
the top and bottom for access tool to
unscrew the screws.
2. Hang the boiler up in a vertical posi-
tion on fixing screws with the inlet and
outlet pipes to the bottom.
3. Connect the boiler to a central heat-
ing system equipped with cut-off
valves.
4. Fill the central heating system with
a treated water that substantially
extends the life of the heating ele-
ments.
5. Vent the wet central heating system.
6. Connect a boiler to the electric mains.
Boilers of 4 and 6kW are factory pre-
set to work as single phase boilers. If
you intend to connect a boiler to the
three-phase electrical sys tem, take
off the wire set [2].
7. Fix the room thermostat, in accord-
ance with its manual.
8. Connect the room thermostat (by
using two wires 2 x 0,35 mm
2
) to the
(RT entry) on controller. In order
to insert the wires to the clamps,
you have to press the switch on the
connecting element with a use of a
screwdriver.
9. Once you have finished the above
procedures, you can start the boiler
according to „start-up” section.

!
Make sure that the room thermostat connection is a voltage free one!
The RT connection is a voltage free connection! Connecting voltage will destroy
the controller.
M4x8
M4x8
C
D
D
C