EXi: STR-1 Plucked String
264
5-2: Multi Filter
This page is available only when the
Filter A Type
is
set to
Multi Filter
.
What’s a Multi Filter?
Standard multimode filters generate lowpass,
highpass, and bandpass filters simultaneously - but
only allow you to use one of them at a time.
The Multi Filter gives you access to all three filter
modes simultaneously, in any combination, along with
the dry input signal. You can choose from a large
number of preset combinations, or create your own
complex filter modes using the Manual controls.
This is capable of some cool sounds in and of itself, but
things really get interesting when you use the
Crossfade controls. These allow you to crossfade
between two of these filter settings (Mode 1 and Mode
2), using AMS sources such as EGs, LFOs, or real-time
controllers.
5–2a: Filter A
Bypass
[Off, On]
Frequency
[00…99]
Fine
[–99…+99]
Resonance
[00…99]
These are the same as the similarly-named parameters
on the Filter Basic page, as described under “5–1b:
Filter A” on page 262.
Edits to the values on this page will be reflected on the
Filter Basic page, and vice-versa.
5-2b: Mode Crossfade
Mode 1
[List of filter types]
This sets the filter type for Mode 1.
Low Pass, High Pass, Band Pass,
and
Band Reject
are
the standard filter types. For more information, see
“Filter Type,” on page 262.
The following types combine two or more filters at
equal volumes.
Dry
is the un-filtered input signal. The
minus sign (“-”) indicates when the phase of a filter is
reversed:
LP+BP, LP-BP, LP-HP, BP+HP, BP-HP,
Dry+LP, Dry-LP, Dry+BP, Dry-BP, Dry+LP-HP,
Dry+LP-BP, Dry+BP-LP, Dry+BP-HP, Dry+HP-LP,
Dry+HP-BP, LP+HP+BP
.
All On
uses the Low Pass, High Pass, Band Pass, and
Dry signals at equal volumes.
Manual 1 lets you create your own mix of the filters.
For more information, see “5-2c: Manual 1,” below.
Mode 2
[List of filter types]
Mode 2 has the same selections as Mode 1, except that
the list ends with Manual 2 instead of Manual 1.
Mode 1-2 Crossfade
[0…99]
This fades between the Mode 1 and Mode 2 settings.
0
is all
Mode 1
,
99
is all
Mode 2
, and
1-98
are
intermediate values between the two Modes.
AMS
[AMS Sources]
This selects a modulation source to control the
Mode 1-
2 Crossfade
. For a list of AMS sources, see “AMS
(Alternate Modulation Source) List” on page 967.
5–2PMC
5–2c
5–2b
5–2a
5–2c
Содержание Electronic Keyboard
