14
Note: Please modify the IP address of your target devices. The scan feature can’t
browse the devices which have the same IP address. Only one of the devices which
have the same IP address can be found. This is the current restriction. Please modify
the IP address first. You can use web browser, Block I/O Utility or Device Finder to do
the IP modification.
3. Click “Add” to add the available JetI/O units. Then you can see the JetI/O units are
listed in the left column.
4. Move the mouse over to one of the JetI/O units. Select the unit then you can configure
and monitor the configurations of the JetI/O. The features Block I/O Configuration utility
provides are similar please find your model name and go to its configuration introduction
chapter in below.
4.1.3 JetI/O
6510
Configuration
4.1.3.1 Go
to
“General”
page. You can view the current settings, modify the IP address,
Subnet mask, Default Gateway, Enable or Disable DHCP Client mode, select the
Input range of this device and check the Firmware version. After modified the
network setting, press “Update” to active the new setting. The indicator will show
green when update successfully.
