19
2. Type
ping 192.168.1.1
command to check the connection. Here we
use IP address 192.168.1.1 as an example.
3. Repeat step 10 to make sure that the connection of each device linked
to the JetCon Converter is successfully established.
4. Power on the PC host, activate the Command Line mode, and ping the
connected Ethernet device by typing “ping 192.168.1.1 –t” command
to see if it will respond. Remember that the PC host IP address is the
same subnet address as that of target device – 192.168.1.1.
5. The parameter-”t” allows you to continue to ping the network device,
as shown in the figure below.