12
3. DIN Rail Mounting
The DIN Rail clip is screwed on the rear panel of the device which supports
EN 50022 type rail installation. The following diagram includes EN50022
rail dimensions for your reference.
The DIN rail should be behind
the spring when installing the
JetCon device onto the
standard DIN Rail.
Follow the steps below to
mount the JetCon 2302 on
the
DIN-Rail track.
1. Insert the upper end of the
DIN-Rail clip into the back of
the DIN-Rail track from its
upper side.
2. Lightly push the bottom of the
DIN-Rail clip into the track.
3. Check if the DIN-Rail clip is
tightly attached to the rack.
4. To remove the JetCon 2302
from the track, reverse the
steps above.