Kopp 752150, Инструкция по эксплуатации

Страница: 6 / 22

6
Function setting
Radio broken glass sensor is only a transmitter

.
Any number of receivers in the transmitting range
can be programmed to the switching command.
Combination with other free-control device s
Plug the plug-in jumper into position

for the
following applications:
• Signal evaluation by the radio alarm station
• Switching of radio receivers
- Flush-mounted receiver 1-channel 3-wire
- Flush-mounted receiver 1-channel 2-wire
- Flush-mounted receiver 2-channel or blinds
- Flush-mounted receiver buttons or time function
- Flush-mounted receiver dimmer function for
electronic transformers (switch on/off function)
- Flush-mounted receiver dimmer function for
conventional transformers (switch on/off function)
- Lamp socket
- Adapter switch function
- Adapter dimmer function (switch on/off function)
- Grounding-type multiple socket outlet
Sabotage contact is not active here.
Plug the plug-in jumper into position

for the
following applications:
• Signal evaluation by the radio burglary alarm
center
• Signal evaluation by the PC-Software for burglary
alarm center
Sabotage contact and magnetic sensor are constant-
ly monitored here.
Broken glass sensor only transmits „On“ signal.
Switching off radio receivers with a separate radio wall
switch or radio hand transmitter master button „0“.
Programming to radio receiver and/or radio alarm station
Plug the plug-in jumper into position

.
Activate the programming mode of the receiver (see
separate operating instructions).
Press PROG button

< 1 second.
LED

illuminates for 3 seconds.
Broken glass sensor transmits two signals.
First ON then OFF signal within 2 seconds
Receiver LED must blink 2x.
Programming process is terminated automatically.
Programming to radio burglary alarm center and/or
PC-software for burglary alarm center
Plug the plug-in jumper into position

.
Activate the programming mode of the receiver (see
separate operating instructions).
Press PROG button

< 1 second.
LED

illuminates for 3 seconds.
Programming process takes place automatically.
If programming was not successful:
Note instructions in the troubleshooting section
(FAQ) at
www.free-control.com .
Status notification
Status notification is transmitted every 4 hours.
Evaluation by radio burglary alarm center, PC-Soft-
ware for burglary alarm center.
The following is monitored:
• Battery capacity
• Broken glass sensor
• Sabotage contact
