1)Fill the Water Tank with water:
CAUTION:
Make sure that the STEAM MOP is unplugged.
Turn the Water Tank cap counter-‐clockwise approximately 90°to the
“OPEN” position and remove the cap as illustrated.
Hold the Mop at a 45°angle as illustrated in Fig.1d. Add water in the tank up
to the MAX level by using the measuring cup.
Do not overfill,the maximum tank capacity is 450ML±20ML.
Replace the Water Tank cap and turn clockwise approximately
90°to the “CLOSE” position until the cap is tightened securely.
The STEAM MOP uses tap water. However, in areas with hard water, distilled
water should be used for better performance.
Make sure the Copper Cone inside the Water Tank is always
submerged in water(As illustrated in Fig.1i)while operating
The STEAM MOP.
NOTICE
Never put cleaning detergents or scented products in to the STEAM MOP.
This will make operation unsafe and damage the unit.
2 )Rotating the steam switch to adjust the size of steam.
You can adjust the Steam flow control and the steam output while operating the STEAM MOP.
3) Once the unit has been fully assembled and filled with water, plug in the Power Cord to
a grounded electrical outlet. Turn the Power Switch (O/ I) from the OFF(O) to the ON(I) position.
After approximately 30 seconds, turn on the steam regulator ,and adjust the steam according
to your requirement. The Mop will start emitting steam. To stop emitting steam, turns off
the steam regulator and then turns the Power Switch (O/ I) to the OFF(O) position.If you turn the
Power Switch (O/ I) to the ON(I) position, and then you turn on the steam
regulator earlier than 30 second, water from the previous use will not be heated and will be forced out
by present steam and will cause pudding to occur.This may also happen if you just turn off the Power
Switch to the OFF(O) position and left the steam regulator on from the previous use and the
unit was disconnected by unplugging only. Make sure to turn the unit totally OFF after each usage and the
disconnect from the electrical outlet so the unit is in the totally OFF when used next time.
4) Slowly pass over the surface to be cleaned. The absorbent mop cloth picks up the dirt loosened by the steam. Apply steam liberally. Keep a towel
handy and wipe away any excess water that may accumulate.
5) When the STEAM MOP stops emitting steam, simply turn off and unplug the appliance, refill the Water Tank and continue cleaning.
HAND-‐HELD STEAMER
The Hand-‐Held Steamer is an ideal portable cleaner for use on work surfaces, counter tops, sinks, windows, mirrors, tiles and spot cleaning on
floors, carpets and ugs. Use it with the Jet Nozzle, Brass brush or Nylon brush attachments to spray away dirt, grease, mold and more.
HOW TO ASSEMBLE HAND-‐HELD STEAMER
CAUTION:
To attach the Jet Nozzle: Insert the Jet Nozzle into the
designated hole in the Main Body unit until it locks in place with
the Lock Button on the Main Body (you will hear a clicking
sound), as illustrated in Figure
Make sure that the Jet Nozzle is securely locked in place before usage.
Attach either the round nylon brush or round copper brush by screwing onto
the threaded end of the Jet Nozzle as illustrated in Fig.5a,b.
5a 5b
Содержание 2409464
Страница 9: ......
