VII. Specific Model Data
Mounting
Kooltronic Air Conditioners have been engineered to be installed easily. To avoid damaging your Air
Conditioner, please read the following information before installation:
1. Remove and save the four screws holding the Mounting Template and Assembly Bracket (M/TAB) to the
unit. Remove the M/TAB.
2. See Figure 1 for proper M/TAB orientation.Place the M/TAB flush against the outside of the cabinet to
locate cutouts and mounting holes.
3. NOTE: The top cutout for the warm air return does not have to match the full 9" opening on the M/TAB.
You can locate your cutout anywhere within this opening. Locate your cutout close to the top and not
less than 4" high. Make sure the cutouts don't interfere with components inside your cabinet.
4. Mount the M/TAB to the outside of the cabinet using all the mounting hardware supplied by Kooltronic
(
1/
4
-20 screws/nuts/washers). NOTE: Make sure the screws are inserted with heads on M/TAB side.
Tighten nuts securely.
5. Route the power cord through the top cut out in your cabinet. Mount the unit to the M/TAB by sliding the
studs located on each side panel into the slots on the M/TAB.
6. Insert the remaining 10-32 screws and seal washers supplied by Kooltronic through the air conditioner
side panel and into the M/TAB. To avoid misalignment of parts do not tighten any of the screws until they
are all installed. Be careful not to overtighten the screws.
7. The drain hose must not be elevated above the exit port. Improper mounting will impede the flow of
condensate and may cause internal malfunctions.
CAUTION
7
If the air conditioner is mounted to the cabinet door you must be sure
that the door hinges will support the additional weight of the air
conditioner. Also be certain that when the door is opened fully, the
cabinet does not become unbalanced. The actual weight of the unit can
be found in the performance specifications.
Dimensions, inches [metric], are for reference only and are subject to change.
ENCLOSURE
AIR OUT
CONDENSER AIR
OUT (3 Places)
ENCLOSURE
AIR IN
CONDENSER AIR
IN (Filtered)
12.00
[304.8]
47.26
[1200.4]
12.50
[317.5]
15.12
[384.0]
13.31
[338.0]
TYP.
.87
[22.1]
TYP.
1.53
[38.9]
DIA. HOLES
(12) .312 [7.9]
7.00
[177.8]
TYP.
10.13
[257.3]
TYP.
18.00
[457.2]
27.62
[701.5]
.75
[19.0]
3.00
[76.2]
1.28
[33.2]
POWER
CORD
FIGURE 1
MOUNTING PLAN
