Kooltronic Compact K2A4C1HTL, Руководство оператора

Страница: 5 / 13

5
Kooltronic Air Conditioners are required when the equipment operating temperature must be kept near or lower
than the ambient room temperature, and/or the cabinet must be sealed from dust, fumes, oil, corrosives and other
contaminants. This Air Conditioner utilizes a "Closed-Loop Cooling System" to ensure optimum performance of the
installed components.
Closed-Loop cooling seals the electronics enclosure from hostile elements in the environment. Two separate
circulation systems are employed. The internal system cools and dehumidifies the air inside the cabinet, totally
isolating the sensitive electronics and other components from the environment. The external system uses
circulating ambient air or water to discharge the heat removed from the electronics.The heat is dissipated from the
enclosure by means of the vapor compression refrigeration cycle. This takes place in a hermetically-sealed
refrigeration system, utilizing either an air-cooled or water-cooled condenser heat exchanger. The warm air inside
the enclosure is drawn through the evaporator coil where it is cooled, dehumidified and returned.
Any enclosure moisture accumulated on the evaporator coil is collected in the condensate tray and released to the
ambient air through the drain tube or the condensate evaporator.
The heat removed through the evaporator coil is transferred by the compressed refrigerant to the condenser coil.
Ambient air or water is then passed through the condenser coil, where it absorbs the heat and is then discharged
to the environment.
The cool air discharge temperature is regulated by the capacity control (hot gas bypass) valve. The unit is
equipped with a Low Temperature Thermostat to prevent over-cooling. In applications having frequent voluntary
heat load fluctuations, a Short Cycle Protector is recommended.
V. Principles of Operation
CONDENSER OUTLET
(Heated Ambient Air Out)
CONDENSER HEAT
EXCHANGER
CONDENSER AIR
INLET
(Ambient Air In)
REFRIGERANT
FILTER DRIER
CONTROL
BYPASS VALVE
METERING
DEVICE
(Capillary Tube
shown)
COMPRESSOR
EVAPORATOR
HEAT EXCHANGER
COOL AIR TO
ENCLOSURE
ACCUMULATOR
CONDENSER
AIR INLET
(Ambient Air In)
HEATED AIR FROM
ENCLOSURE