Kontron Embedded Modules GmbH
Flatpanel Solutions
Marschnerstieg 7
22081 Hamburg / Germany
Fon: +49 (0)40 20 00 90-0
Fax: +49 (0)40 20 00 90-10
http://www.kontron-emea.com/flatpanel
X-BOARD-UPA
08.09.2004
4
2.0
Technical Information Summary
X-Board-UPA is an Evaluation Board (only for development) for VGA,
SVGA, XGA type TFT flatpanels to Kontron JILI interface with digital output
option.
CAUTION
: Don´t connect this cable to a JILI Interface with LVDS output!
This can cause permanent damage to all connected devices!
3.0
Configuration
The X-Board-UPA is configured with +3,3V DC for the flat panel power
supply and +12V DC for the backlight power supply.
3.1
Configuration SW1
Configuration: Function:
Dip 1
Inverts the Data Enable signal
ON = not invert, OFF = invert
Dip 2
Inverts the V-Sync signal
ON = not invert, OFF = invert
Dip 3
Inverts the Panel Data Clock signal
ON = not invert, OFF = invert
Dip 4
Inverts the H-Sync signal
ON = not invert, OFF = invert
Dip 5
Select Data mapping
ON = U5 active, OFF = U6 active
Dip 6
Not function
3.2
Configuration SW2
Configuration: Function:
Dip 1
Programmable strobe select, only for LVDS output
ON = Rising edge strobe, OFF = Falling edge strobe
Dip 2
Vertical display mode select signal, only for X7
ON = U/D low, OFF = U/D high
Dip 3
Horizontal display mode select signal, only for X7
ON = R/L low, OFF = R/L high
Dip 4
VGA/QVGA mode select signal, only for X7
ON = Q/V low, OFF = Q/V high
Dip 5
Power for serial eeprom (JILI File)
ON = enable eeprom, OFF = disable eeprom
Dip 6
Power for D/A converter (Backlight dimming control, only for X9)
ON = enable D/A converter, OFF = disable D/A converter
