Kontron MOPSlcdGX1, Руководство по эксплуатации продукта

Страница: 30 / 71

MOPSlcdGX1 Product Manual IDE-Controller Interface
Kontron Embedded Modules Revision 1.3 24
13. IDE-CONTROLLER INTERFACE
PCI-bus devices serve as primary and secondary IDE hosts on the MOPSlcdGX1. BIOS
automatically configures them, but you can disable them by using the BIOS Setup Utility.
Resources used by primary and secondary IDE host adapters are compatible with the
PC/AT.
The IDE controller supports the following modes:
•
Ultra 33 DMA mode
•
PIO modes up to Mode-4 timing
•
Multiword DMA Mode 0, 1, 2 with independent timing
Use a master/slave daisy chain when connecting two devices to a single adapter.
For more information on IDE-controller interfaces, please see the Appendix G:
Literature and Standards chapter.
13.1 IDE Connector (X5)
The IDE connector is a 44-pin, dual in-line, 2mm-pitch, male header.
To find the location of Connector X5 on the MOPSlcdGX1 board, please see the
Appendix E: Connector Layout chapter.
IDE Connector for 2.5 “ Hard Disk (X5)
Pin
Signal Pin Signal
1 RESET# 2 GND
3 D7 4 D8
5 D6 6 D9
7 D5 8 D10
9 D4 10 D11
11 D3 12 D12
13 D2 14 D13
15 D1 16 D14
17 D0 18 D15
19 GND 20 NC
21 NC 22 GND
23 IOW# 24 GND
25 IOR# 26 GND
27 RDY 28 NC
29 ACK 30 GND
31 IRQ14 32 NC
33 SA1 34 NC
35 SA 0 36 SA2
StockCheck.com