mITX-APL
Doc. Rev. 1.2
www.kontron.com
// 27
6.3.
Flash Memory
The mITX-APL supports eMMC interface 5.0 with a maximum bus speed of 400 MB/s. The board will also support a
SD card interface UHS-I standard with a maximum bus speed of 104 MB/s.
The eMMC chip is soldered on board.
The microSD card interface is sharing a combo connector with the micro SIM card.
Figure 7: Combo Connector for MicroSD and MicroSIM
6.4.
Ethernet Connectors (I/O area)
The mITX-APL supports three channels of 10/100/1000 Mbit/s Ethernet (LAN1 to LAN3).
In order to achieve the specified performance of the Ethernet port, Category 5 twisted pair cables must be used with
10/100 MByte/s and Category 5E, 6 or 6E with 1 Gbit/s LAN networks.
Figure 8: Ethernet Connector
Pin Assignment
Pin
Signal
Ethernet 10
BaseT/100BaseT
Gigabit-Ethernet
1
MDI0+
TX+
DA+
2
MDI0-
TX-
DA-
3
MDI1+
RX+
DB+
4
MDI1-
DC+
5
MDI2+
DC-
6
MDI2-
RX-
DB-
7
MDI3+
DD+
8
MDI3-
DD-
8 7 6 5 4 3 2 1
LED status:
1000 Mbit/s link established
100 Mbit/s link established
Off - 10 Mbit/s Link
established
LED status:
Off – Link is down
Flashing Green: Link is up
and active
Steady Green: Link is up,
no activity
