Kontron KISS4U, Руководство пользователя, Страница: 31 / 60

KISS4U User’s Guide page 31
Integrated Board Supports USB1.1 Supports USB2.0
886LCD(GV) Motherboard
5 5
886LCD-M/ATX Motherboard
5 5
MBATX-945G-VGA Motherboard
5 5
PCI-951 SBC-board
5 5
Power Supply Unit
The power supply unit (PSU) is located on the rear side of the unit. The type of PSU
installed depends on which system configuration is ordered (integrated motherboard or
SBC-board respectively).
For information about the integrated power supply unit (PSU) and the supply voltage of
your system, refer to the type label attached on the right side of the unit.
Upon request, your system can also be equipped with a DC power supply.
Fan Slide-In Module and Temperature Sensors
The two system fans are firmly mounted in a user friendly, exchangeable fan slide-in
module (hot swappable). The fan slide-in module is installed in the fan case located at
the front side of the system. The system fans are temperature-controlled via the
temperature sensors which are built into the system. In this way, sufficient airflow is
ensured for optimal, active cooling of the system.
CAUTION
The KISS-Platform should only be operated with a functioning fan
slide-in module (refer to the “Replacing the System’s Fans”
section).
Defective components should only be replaced with Kontron
original spare parts.
ƒ
the part number of the fan slide-in module: 0-0084-3604
The temperature conditions of the system (dependent on the ambient temperature and
the system load) are acquired by two temperature sensors. One of the temperature
sensors is attached in the rear area of the system (near the air exhaust openings) and
the second one is attached laterally, in the middle of the unit.