8. Assembly, Disassembly
KISS 4U V2 – User's Guide (Version 1.01)
8.
Assembly, Disassembly
8.1.
Attaching the Rubber Feet
The rubber feet can be used for the desktop version of the system.
To attach the rubber feet to the bottom side of the chassis, please perform the following steps:
1.
Turn your system off and disconnect it from the main power supply.
2.
Make sure that all cards are secured into unit and that the system cover is installed and secured.
3.
Turn the system upside down.
4.
Remove the protective film from the self adhesive rubber feet.
5.
Attach the self adhesive rubber feet to the bottom side of the chassis.
8.2.
Cover
The cover will be fixed to the chassis using two fixing brackets at the front side of the cover (Fig. 26, pos.3 and pos. 4),
two fixing brackets with captive knurled screws at the rear side of the cover (Fig. 26, pos.6) and the cover fastening screw
(Fig. 12 and Fig. 13, pos. 14) at the front side of the KISS 4U V2 platform.
When closing the cover, make sure that the fixing brackets (
, pos. 3 and pos. 4) are inserted properly into the
corresponding retaining bracket of the cabinet (Fig. 8, pos. 4). The centering bracket (Fig. 26, pos. 3) and the front cover
fastening screw (Fig. 12 and Fig. 13, pos. 14) secure the cover on the front side.
5
1
4
3
2
6
Fig. 26: Inside of the cover with fixing brackets
1
Inside of the cover
4
Fixing bracket (on the front side)
2
Front part of the cover
5
Rear part of the cover
3
Angulated centering bracket with tapped
hole (on the front side)
6
Fixing brackets with knurled screws
26
www.kontron.com
