3.5-SBC-APL – Rev. 0.1
www.kontron.com
// 20
4.5.
System Memory Support
The 3.5-SBC-APL has 1 GB of soldered down system memory and supports one DDR3L SO-DIMM socket. The sockets
support the following memory features:
DDR3L SO-DIMM 1.35 V (non ECC)
1x SO-DIMM DDR3L socket
Maximum support memory up to 8 GB
Memory controller speeds of 1867 MHz
The installed DDR SO-DIMM should support the Serial Presence Detect (SPD) data structure. This allows the BIOS to
read and configure the memory controller for optimal performance.
4.6.
Graphics
The 3.5-SBS-APL features on-board Intel® HD Graphics (Gen9LP) and supports three display pipes:
DisplayPort (DP)
HDMI
LVDS
Table 6: On-Board Graphics Output
Processor
Graphics
Base
Frequency
Graphic Output
Max. Resolution
Intel® Atom ™ x7 E3950 Intel® HD graphics 505
500 MHz
HDMI
DP
3840 x 2160
3840 x 2160
Intel® Atom ™ x5 E3940
Intel® Atom ™ x5 E3930
Intel® HD graphics 500
400 MHz
HDMI
DP
3840 x 2160
3840 x 2160
Intel® Celeron ® N3350
Intel® HD graphics 500
200 MHz
HDMI
DP
3840 x 2160
3840 x 2160
4.7.
Power Consumption
In order to ensure safe operation of the board, the input power supply must monitor the supply voltage and shut
down if the supply is out of range, refer to the actual power supply specification. In order to keep the power
consumption to a minimal level, boards do not implement a guaranteed minimum load. In some cases, this can lead to
compatibility problems with ATX power supplies that require a minimum load to stay in regulation.
The 3.5-SBC-APL is powered by either a single 12 V DC Power Supply or optionally through an internal ATX 4-pin
power connector using a standard ATX power supply.
Hot Plugging with the power supply is not supported. Hot plugging might damage the board.
ATX+12 V supply: ATX+12V 4-pin connector must be used in according to the ATX12V PSU
standard.
