3. Make sure screw is fully
inside pocket
2. Take up slack.
4. Tighten screw.
Repeat for the other two outer cables. When
they are all fitted you can tuck the excess
lengths underneath the other cables.
NOTE:
It is important that there is no
slack in the outer cables after
this stage. If there is any slack
then the magnets could become
stuck together in the next stage,
if they do then you will have to
detach the outer cables from
the shuttles, slide the magnets
apart, refit the assembly plate
and start again.
1. Loop round screw
Loop one outer cable around its opposite shuttle screw.
1.
Pull
gently
to take up the slack in the cable.
2.
DO NOT PULL THE CABLE TIGHT LIKE A GUITAR STRING!
Make sure the long roundhead screw has been pulled fully into its hole.
3.
Screw the shuttle screw down tightly onto the outer cable.
4.
Tensegrity Table assembly instructions page 43 of 46
Copyright Kontax Engineering Ltd 02/11/21
