1. Fit one magnet into one of the pockets in the assembly plate.
2. Swing the wire loop into the slot in the arm.
3. Screw one grub screw into the arm until it is flush with the top face of the arm.
The screw should pass cleanly through the hook on the end of the wire loop
and screw down flush with the arm. If it feels tight as you screw it in do not force
it. Back the screw off, reposition the hook and try again.
Repeat for the second magnet and wire loop.
1. Fit Magnet
2. Fit Wire Loop
3. Fit screw
Arm shown cut away
for clarity
3. Fit screw
Tensegrity Table assembly instructions page 41 of 46
Copyright Kontax Engineering Ltd 02/11/21
