Remove the assembly plate, the table will be quite
wobbly at this stage.
Use the T6 driver to tighten each screw around the
base until the top plate is held steady and
horizontal. It is best to work around the three screws
in turn tightening each one a little bit each time.
DO NOT TIGHTEN THE CABLES LIKE A GUITAR STRING!
The central cable has an 8kg breaking strain, if you
tighten the three outer cables too tighly you will
break the central cable.
The recommended tension is is just enough so that
when you nudge the Top Plate it wobbles slighty.
The table is not designed to carry heavy loads on
top. You can put light objects (250g) on top for
brief demonstration purposes but it is best to avoid
leaving heavy objects on it permanently.
Tensegrity Table assembly instructions page 12 of 46
Copyright Kontax Engineering Ltd 02/11/21
