Könner & Söhnen KS 7HP-MFM 60, Руководство пользователя

Страница: 10 / 16

Cleaning with the brush and snow shovel
Before cleaning:
1. Move the brush direction lever (B) to the desired position
(see “Brush direction”).
2. Choose a speed depending on the route and job complexity.
3. Engage the brush drive (C).
4. Engage the traction drive (D).
Large areas
• Reduce speed when working on uneven or dirty surfaces to avoid damaging the brush.
• First clear the central area by conventionally dividing the area to be cleared into 2 parts with a strip,
and then clear other areas. This reduces the brush stress.
Snow
• Snow is much easier to remove when fresh. Go through the already cleared areas to remove any
remaining snow.
• When shoveling snow, it is recommended to move down the wind. Check the distance and direction
of the removed snow.
• Reduce speed before turning off the engine.
OPERATION TIPS
OPERATION TIPS
Fig. 15
SAFE OPERATION OF EQUIPMENT
SAFE OPERATION OF EQUIPMENT
• Keep steps, handrails, pedals, and controls free from dirt, grease, debris, and oil.
• Keep bystanders away from the working area of the equipment.
• Carrying people or objects on the engine attachments is not allowed.
• The operator must be in the correct working position when operating the equipment.
• Never leave the equipment unattended with the engine running or with the bucket raised.
• Do not modify or remove any safety parts or devices of the engine or engine attachments.
• Observe the safety rules at your workplace, as well as traffic regulations. If in doubt about any safety issue,
contact your manager or safety coordinator for clarification.
Dirt and gravel
• To reduce the amount of dirt rising up during cleaning, set the brush to a low speed. If possible, also
clean in wet or cloudy weather or after rain.
• For gravel, adjust the brush height to prevent damage to the brush.
Heavy rubbish
• Operate at minimum speed and do not use the full working width of the machine.
Adjusting the height of casters and brushes
As the brushes wear out, their height should be adjusted against the
surface to be cleaned. To adjust the height of the brushes, use the plastic
rings on the casters.
To do so, proceed as follows:
1. Loosen the side lever (A).
2. Turn the top lever (B) clockwise to raise or counter-clockwise
to lower the small wheels.
3. Secure the side lever (A).
Fig. 16
In an emergency, release the levers as soon as possible
and stop the engine.
WARNING - DANGER!
А
С
В
А
В
D
www.ks-power.de/en | 9