Konix Drakkar Aurora, Руководство пользователя

Страница: 3 / 19

4 5
fig 3
fig 2
2
4
fig 4 fig 1
4
1
2
3
CONTENTS
1 x LED strip
1 x Remote control
1 x Cable holder
1 x User manual
PARTS DESCRIPTION
INSTALLATION
- Remove the protective film and stick the adhesive strip 4 to a smooth, clean, and dry
surface.
- Connect the LED strip 1 to the USB connector (fig. 1).
OPERATION
- Ensure that the infrared diode 2 of the LED controller is not covered and can be
controlled with the remote control 3 without obstructions (fig. 2).
- Remove the safety strip in the battery compartment before switching the LED strip on.
- Remote control button functions (fig. 3)
A
Button Function
1 Increase brightness.
2 Decrease brightness.
3 Switch the LED strip off.
4 Switch the LED strip on.
5 Rapid colour change without blending.
6 Slow colour slowly without blending.
7 Slow colour slowly without blending.
8 Rapid colour change with blending.
9-24 Select the desired colour.
A
1 : LED strip
2 : Infrared diode (receiver)
3 : Remote control
4 : Adhesive strip
SHORTENING THE LED STRIP
- Disconnect the LED strip 1 from the USB connector before performing any work on it.
- Shorten the LED strip 1 to the desired length by trimming the last section in the line.
- The cutting point is in the exact middle between the positive and negative poles, and is
marked with a white line and a scissors symbol.
- Cover the open end of the LED strip 1 with the adhesive strip 4 before use (fig.4).