8
Single Satellite Search
1. Satellite:
Press the
keys to select the circled satellite. Or press the
OK
key to open the
drop-down list to select the desired satellite. Press
OK
key to confirm.
2. FTA Only:
Press the
keys to select between Yes and No.
3. Scan Channel:
Press the
keys to select between TV+Radio, TV Channel and Radio.
4. Network Search:
Select No or Yes. This item turns grey when Auto Scan is selected in the
following Scan mode item.
5. Scan Mode:
Press the
keys to select between Auto Scan and Preset Scan. Auto Scan is
a blind scan, while Preset Scansearches for the preset frequencies.
6. Search:
Press the
OK
key to start searching.
Factory Settings
Press the
OK
key to enter the
Factory Setting
window.
Select the
Yes
button and press the
OK
key to return to the factory settings. All searched channels
and set information will be erased.
Select the
No
button and press the
OK
key to cancel this operation. Press the
MENU
or
EXIT
key to
cancel and exit.
Upgrade by USB
1. Upgrade File: Show the Upgrade File.
2. Upgrade Mode: Select between allcode, maincode, defaultdb, userdb and Dump. When switching
the upgrade mode, “Upgrade File” will show the corresponding file according to the table below:
Upgrade Mode
File feature
All code:
File named as “*.abs”
Main Code:
File named as “*.abs”
Userdb: File
named
as “*.abs”, the
picture will be used as
both radio back and menu
back
Default db:
File named as “*.abs”
Select the upgrade mode and upgrade file to start the upgrade by USB.
3. Press the
OK
key on the start button to start receiving data from the USB device. When the USB
device is not connected, this item is grey and you cannot edit it at this moment.
TROUBLESHOOTING
Problem
Possible causes
What to do
The display on the front panel
does not light up.
Main cable is not connected.
Check if the main cable is
plugged into the power socket.
No sound or picture, but the
front panel shows red light.
The receiver is in standby mode. Press the standby button.
No sound or picture.
The satellite dish is not pointing
at the satellite.
Adjust the dish. Check the signal
level in the Antenna Setup menu.
