E-4
(5) Attach the Punch kit wire bundle to the four wire
saddles.
13. Align the control board cover with the grooves
and slide in the board, then secure. (1 screw)
14. Install the Punch waste box, and close the fin-
isher’s front door.
15. Install the finisher to the machine.
Note:
• Check that the machine installation plate/ lower
(Finisher accessory parts) hook is securely set
on the finisher when installing the finisher to the
machine.
• Refer to the finisher installation manual for details
on installing the finisher to the machine.
16. Software DipSW setting.
17. Paper edge detect sensor adjustment.
A04EIXE005SA
Wire saddles
15KJIXE017SA
Control board cover
15KJIXE018SA
P
unch
w
aste bo
x
Step
1. Plug the power cord into the outlet and turn
ON the Main power switch.
2. Enter Service mode.
Note:
Refer to procedures in the Service Manual to
enter into the Service Mode.
3. [Service Mode menu screen]
Touch “System Setting”.
4. Touch “Software SW Setting”.
5. Set 22-1-0(OFF), 22-2-0(OFF), 23-7-0(OFF)
and touch “Return”.
6. Turn OFF the Sub power switch and Main
power switch.
Step
1. Turn ON the Main power switch.
2. Enter Service mode.
Note:
Refer to procedures in the Service Manual to
enter into the Service Mode.
3. [Service Mode Menu screen]
Touch “Finisher Adjustment”.
4. [Finisher Adjustment Menu screen]
Touch “Punch Adjustment”.
5. [Punch Adjustment Menu screen]
Touch “PaperEdgeDetectSensorAdj.”.
6. [Paper Edge Detect Sensor Adjustment screen]
Touch “Start”.
7. When adjustment is done correctly, message
of “Completed” is indicated.
8. Turn OFF the Sub power switch and Main
power switch.
A04EIXE00
6
SA
M
achine
Lo
w
er vie
w
Finisher
Securel
y
installing
the finisher to the
m
achine.
