E-2
5. Making sure the direction is correct, install the
control board on the control board supports.
Note:
When installing the control board, mount it so that
the notched portion of the control board faces the
front.
6. Pass the Punch kit connectors of the sensor assem-
bly wire bundle through the hole and attach the wire
bundle to the eight wire saddles.
Note:
• Let the control board side connectors hang down
to the bottom.
• Let the first wire bundle of the Punch kit con-
nectors hang out from the hole, as shown in the
figure.
7. Temporarily tighten the screw (TP screw M3x6: 1
pc.) on the back side of the finisher. Position the
sensor on the sensor assembly wire bundle with
the projection then fasten with the temporarily
tightened screw.
Note:
Make sure pass the sensor assembly wire bundle
on the right side of the sensor.
8. Connect the sensor assembly wire bundle connec-
tors (4 locations) to the control board connectors.
9. Attach the wire bundle to the four wire saddles.
A04EIXE001SA
Notched portion
Control board
15KJIXE003SA
Bundled
portion
Wire saddles
Wire saddles
15
K
J
I
X
E
00
4
SB
TP
scre
w M
3
x6
Sensor
asse
m
b
ly wi
re
bund
l
e
Sensor
A04EIXE002SA
Connectors
Connector
A04EIXE003SA
Wire saddles
