Konica Minolta IC-301, Руководство пользователя, Страница: 180 / 212

172 Appendix A– Setting Parameters
Finisher Module
Tray
¾
Select one of the following exit trays for your printed output:
•
Paper Exit tray:
Use this option if a finisher is not connected.
•
Sub tray:
Prints to the finisher’s upper tray
•
Main tray:
Prints to the finisher’s stack tray
• The
Offset
check box is selected by default. If you don’t
want to use an offset between sets, clear this check
box.
•
The
Staples
list enables you to specify where you want
to position the staples on the page.
•
The
Punch
check box is active only if a punch kit is
available. There are three punch units available, 2 hole,
3 hole , or 4 hole.
•
Booklet tray:
Prints to the booklet finisher
•
In the
Tray
list, select the fold type.
Center Fold
folds your
booklets in the center of the page.
3-Fold
folds your
booklets in an accordion fold.
• Select the
Staples
check box if you want center staples.
•
The
Trim
check box is active only when a trimmer unit is
available.
Print Order
Collated
¾
Select this check box to print a complete copy of the job before
the first page of the next copy is printed.
Reverse print order
¾
Select this check box to set the print order from back to front.
Note: If you want to staple or punch the other side of your job, select the
Rotate 180
check box on the
Print Method
parameter.