Konica Minolta DRYPRO 873, Руководство по эксплуатации

Страница: 70 / 124

70
Maintenance Mode
4
Use the [Test print] and [Calibration] buttons to move the cursor.
The selected setting changes in the following order.
[Sleep Mode Use] → [Sleep Mode Timer] ([Digit 1] → [Digit 2] → [Digit 3]) →
[OK] → [Sleep Mode Use] → • • •
5
Press the [Service/Enter] button to select the item.
• [Sleep Mode Use]
Press the [Service/Enter] button to enable or disable the sleep mode.
[ON] → [OFF] → [ON] → • • •
• [Sleep Mode Timer]
Press the [Service/Enter] button to set the number of minutes until the sleep mode
is activated. Select a number from [0] to [9] for each of the three digits.
[0] → [1] → • • • [8] → [9] → [0]
Set this between 20 and 720 minutes.
You cannot set to less than 20 minutes or more than 720 minutes.
6
Move the cursor to [OK] and press the [Service/Enter] button to save the
settings�
(If the following message appears, the settings were not saved properly. In this case,
shut down the main unit, restart it, and then configure the settings again.)
7
When the [Reset/Cancel] button is pressed after changing the settings, a
save confirmation message appears.
8
Use the [Test print] and [Calibration] buttons to move the cursor to [YES] or
[NO].
9
Press the [Service/Enter] button to select the item.
Select [YES] to save the settings. The maintenance menu appears.
Select [NO] to return to the maintenance menu without saving the settings.