Konica Minolta Drypro 832, Руководство пользователя

Страница: 45 / 84

1
2
3
4
5
6
7
8
9
1 0
1 1
1 2
45
3�5 Test Print
When test print is performed, the QC pattern for evaluating the image quality is printed. The density
of the QC pattern is measured with the built-in densitometer at the same time and the density is auto-
matically checked. You can check the image quality for problems by visually checking the printed QC
patterns. Perform test print for each supply tray (if Lispl-832 is installed).
This section describes how to print QC patterns from the operation panel of the main unit. For infor-
mation about the operation of test print in general, see "5.2 Operation of Test Print" (page 65), and
how to judge the results after printing QC patterns, see "5.2.3 How to Judge QC Pattern" (page 67).
To print QC patterns, perform the following steps.
1
Press the [Test print] button on the operation panel�
The following message appears in the message display window.
If an optional Lispl-832 is installed
Pressing the [Reset/Cancel] button switches to Tray 2. Pressing the
[Reset/Cancel] button again returns to the state (“Ready” appears in the message
display window) before pressing the
[Test print] button.
2
Press the [Open/Enter] button�
The following message appears in the message display window.
The QC patterns as shown below will be printed.
The message display window goes back to the normal display (“Ready”).