Konica Minolta Bizhub 222, Руководство по обслуживанию

Страница: 443 / 846

11. Soft Switch Settings Field Service Ver. 1.0 Dec. 2008
56
FK-503
ADJUSTMENT/
SETTING
MODE Factory setting bit
007
Bit: 7 6 5 4 3 2 1 0
1 0 1 1 0 1 0 1
HEX:B9 (For U.S.)
HEX:B5 (For Europe)
Bit Feature
Logic
Description
0 1
7 Select upper limit of cut-off
length after printing:
When a received document
is longer than the print paper
and if the excess length is
shorter than that specified
here, it is cut off.
If it is longer than that value
specified with these bits, it is
split into multiple pages. This
feature is enabled when the
following 2 conditions are
satisfied:
• When printing a received
document
• When bit 1 of this mode is
1 <*>
Bit 7-5: 000 0 mm If the excess length is
longer than specified
here:
<For reduction>
• If Bit 1 is set to 0, it is
reduced when fitting
within the reduction
percent range speci-
fied with Bits 4 to 2.
<For division>
• If Bit 1 is set to 0, it is
divided when not fit-
ting within the reduc-
tion ratio range
specified with Bits 4
to 2.
• If Bit 1 is set to 1, the
excess length por-
tion is divided.
6 001 8 mm
5 010 12 mm
011 14 mm
100 18 mm
101 20 mm
110 24 mm
111 Not
available
4 Select upper limit of reduc-
tion ratio of received docu-
ment:
When a received document
is longer that the print paper,
it will be reduced to fit the
paper with the upper limit
specified with these bits. This
feature is enabled when the
following 2 conditions are
satisfied:
• When printing a received
document
• When bit 1 of this mode is
0
Example: The reduction is
100 to 90% when “90%” is
specified. <*>
Bit 4-2: 000 100 % Reduction will not be
done if a received doc-
ument is still longer
than the paper for a
specified reduction.
3 001 95 %
2 010 90 %
011 85 %
100 80 %
101 65 %
110 60 %
111 Not
available