Kongsberg K-Sync, Руководство оператора, Страница: 43 / 62

OPERATIONAL PROCEDURES
Table 4 Scheduling state
State Description
When state is disabled, the echo sounder
has been disabled by operator and
Synchronizing Unit will not trigger this
echo sounder (i.e. enabled checkbox is
unchecked).
When state is standby, the echo sounder
has timed out or is not ready. It will not
be scheduled again until the condition
that caused a timeout is no longer present
(that is, ready to transmit signal becomes
active again. Refer to Section 4.10 on
Troubleshooting for more information).
When state is active, the echo sounder
can be scheduled and no known
condition is preventing it from pinging
next time it is triggered.
• The maximize LED and the master indicator convey if these settings are enabled for
this echo sounder (see section Runtime settings on page 42 for more information).
• The active period displays the duration in seconds from time of trigger until echo
sounder has completed its ping cycle. It shows the latest recorded value. The inverse
of this value is the maximum theoretical ping rate if this echo sounder was triggered
by itself. If the echo sounder is set to calculated or fixed period trigger mode with
no
Ready to transmit or Transmitting signal available, then K-Sync has no way of
knowing the actual state of the echo sounder. Hence the state of the echo sounder will
remain active until disabled and the value will simply reflect the timing parameters
in runtime settings.
Important
In the case that a system times out or fails to transmit three times in a row (echo
sounder in standby state), it is possible to re-enable the system by unchecking and then
rechecking the enabled checkbox.
342435/B
41