Kongsberg cJoy OT, Руководство оператора

Страница: 103 / 208

Operating procedures
In high speed operations (e.g. in the optional Autopilot mode) all enabled speed sensors
will normally be in use (unless a sensor has failed) when speed measurements are used
by the system. It is recommended to also enable manual speed input since the manual
value will be updated based on the in use sensors. Should all sensors be lost, you will
have an initial manual value that reflects the real situation.
Displayed Speed information
You can examine the status and measured values for the speed sensors on the Sensor
view (see
Sensor view on page 38).
Enabling a speed sensor
To enable a speed sensor, proceed as follows:
1
Display the Sensor Enable input dialog for speed sensors.
2 Check that the colour of the
Ready
field for the speed sensor is green.
3
Move the focus to the
Enable
field for the speed sensor and change the option to
On
.
4 Press the Enter button.
• The speed sensor is enabled.
• If a high speed operation is selected the
Use
field for the speed sensor changes
to green.
5 Close the Sensor Enable input dialog.
Disabling a speed sensor
To disable a speed sensor, proceed as follows:
1 Display the Sensor Enable input dialog for speed sensors.
2 Move the focus to the
Enable
field for the speed sensor and change the option to
Off
.
3 Press the Enter button.
• The speed sensor is disabled.
4
Close the Sensor Enable input dialog.
Entering and enabling a manual speed value
To enter and enable a manual speed value, proceed as follows:
1
Display the Sensor Enable input dialog for speed sensors.
2 Ensure that all speed sensors are disabled (see Disabling a speed sensor on
page 103).
3 Move the focus to the
Value
field and change the value to the required speed.
4
Move the focus to the
Manual SPD
-
Enable
field and change the option to
On
.
5 Press the
Enter
button.
• The manual speed value is enabled.
385585/C
103