EN - 16
will turn all heaters on.
Touch Control Safety Functions
The following safety functions are available
to avoid unintended operations.
Sensor Safety Cut Off
To prevent the appliance from unwanted
button operation, button monitoring is
included. In cases where one or more
buttons are pressed for longer than 12
seconds, there is an audible noise to
indicate an incorrect operation (pot or other
object placed on the button, sensor failure,
etc.) and the appliance switches off.
The safety turn off causes that the hob
to go into S-Mode. An ´
F
` will flash in all
heater displays.
If residual heat is present, it will be
displayed on all other heater displays.
The hob control will then go into S-Mode.
At the same time a buzzer sounds. After 10
minutes the buzzer will stop.
Once the incorrect operation has been
cleared, the audible and visible warning
singals will stop.
Over Temperature Switch Off
Due to the controls being very close to the
heater in the middle of the front of the hob,
it can occur that an incorrectly placed pot is
not sensed by the sensor safety cut off (not
covering a button) and heats up the hob to
a very high temperature, which makes the
glass and the buttons dangerous to touch.
To prevent the hob control unit from
damage, the controls constantly monitor the
temperature and switches off if overheating
occurs.
This is indicated in the heater displays
with the letter ´
t
` time until the temperature
decreases.
Once the temperature decreases ´
t
` will no
longer be displayed and the hob control unit
reverts back into S-Mode. This means that
the user can reactivate the appliance by
touching .
Operating Time Limitations
The hob control unit has a limitation on
the operating time. If the heat setting for a
heater has not been changed for a certain
time, the heater will turn off automatically
(for 10 sec a ´
0
` is displayed. Some
residual heat may be present). The limit of
the operating time depends on the selected
heat setting. If a timer was associated with
the heater, ´
00
` will be shown on the timer
display for 10 sec. After this, the timer
display turns off.
After a heater has been automatically
turned off, as described above, the heater
can be used and the maximum operating
time for this heat setting is applied.
Residual Heat Functions
After all cooking processes there is some
heat stored in the vitroceramic glass
called residual heat. The appliance can
calculate roughly how hot the glass is. If
the calculated temperature is higher than
+ 60 °C, then this will be indicated in the
corresponding heater display. After the
heater or the hob control has been turned
off, the residual heat display is shown as
long as the calculated heater temperature is
> + 60 °C.
The residual heat indicator has the lowest
priority and is overwritten by every other
display value and during safety switch offs
and the displaying of error codes. When
voltage is supplied to the hob after a power
interruption, the residual heat display
indicator flashes. If a heater had a residual
heat of g 60 °C before the power
interruption occurred, the display will flash
while the residual heat remains or until
the heater is selected for another cooking
operation.
Содержание UKE6040KOCVSBR
Страница 35: ......
