20
Mode for checking the performace each control.
To return to the main menu, press both the trigger button and the missile button at
the same time.
5 PCB settings
5-3 Mode descriptions
The original factory settings are displayed in green; the changed settings are
displayed in red.
·After the settings have been changed, select the "SAVE AND EXIT" and pull
the trigger. The new settings are saved automatically and the screen returns to
the main menu.
·If "EXIT" is selected after the settings have been changed, the message
"YOU DID NOT SAVE, DO YOU WANT TO SAVE? YES / NO" will appear.
Using the control lever, select "YES" or "NO" and pull the trigger.
If "YES" is selected, the message "NOW SAVING" will appear, the modified
settings will be saved, and the screen will return to the main menu.
If "NO" is selected, the message "NO MODIFICATION" will appear and the
modified settings will not be saved.
•When “FACTORY SETTINGS” is selected and the trigger is pulled, all the
settings return to the factory settings.
MEMO
I/O CHECK
Checking the controls
CONTROL LEVER
VERTICAL +0000
(8020)
TRIGGER :OFF TEST SWITCH :OFF
MISSILE :OFF SERVICE :OFF
POWER UP :OFF COIN MECH :OFF
VIEW :OFF LAMP STATUS :
MAIN TRIGGER AND MISSILE = EXIT
I/O CHECK
UP
DOWN
NEUTRAL
+--+-------------+-------------+--+
HORIZONTAL +0000
(8020)
LEFT
RIGHT
NEUTRAL
+--+-------------+-------------+--+
·Position changes corresponding to entered value.
·Indicates decimal (hexadecimal) figure of the value
set by control lever. It is normal when the mark “ ”
comes to DOWN position with the lever being pulled
fully toward you and when the mark “ ” comes to UP
position with the lever being pulled fully far from you.
·Indicates decimal (hexadecimal) figure of the value
set by control lever. It is normal when the mark “ ”
comes to RIGHT position with the lever being pulled
fully to the right and when the mark “ ” comes to LEFT
position with the lever being pulled fully to the left.
